What's new to be considered when installing your sink?

Identification of the sink

The valve position determines the location of the new sink. Valve and the distance between the midpoint of the wall in pencil and draw a vertical line to the mark. Try holding the sink against the wall after the middle point, just before the line you draw must be aligned with. Floor coverings typically between the top edge of the sink should be down to 82-86 cm. Mark the mounting holes on the wall and leave the sink. The suspension will carry into the sink to the screw holes of the Open. Strap on one side of the screw is a wood screw, this screw will go into the wall anchors. On the other side, which will be determined later, the dish has a metal screw nut. Hanger screw with a special key into the screw hangers. Up to 5 cm from the wall of metal screws leave out, and screwing over the sink to hang long enough for this. As a precaution, once again, the distance between the wall with mounting nut, whether or not to measure the thickness of the sink. In case of a continuous flexible cord into the wall behind the sink and the sink on the hanger, push the screw.

If a cord, continuous flexible wall behind the sink and sink into it over the suspension of the screw. Your help of a suspension compressing screw nut of the dish you hold the correct position.

Connecting valve

Install drain valves: each of teeth of the screw around the oakum Wind (pastes for sealing your roll on), turn the water inlet valve in the line should look up at the end of the pivot.

Placement of the siphon

Flush into the wall to drain, flush with the wall of the drain pipe cross section to compensate for differences with a rubber sleeve. Otherwise, no water can drip down the wall.